IVT技术支持中心--IVT设计 NAP常见问题解答

|

|

产品

|

新闻

|

|

招聘

|

|

下载

|

技术支持

技术支持中心

什么是蓝牙

产品常见问题解答

用户注册

IVT NAP Frequently Asked Questions
	Why we should input the password? If the selected "security mode" is "device security", it is needed to input the password. The default password is "root". If the selected "security mode" is "no security", the following dialog won't appear.
	Why can't we connect to NAP after NAP was reset? It is probably caused by the link key. The link key is saved in the RAM of NAP. After NAP is reset, the ling key is not available. To solve the problem, just reconnect the NAP.
	I have connected my computer to the PAN/NAP, but the network doesn't work well. For example, my IP Address is 192.168.0.58, but when another computer in this network run the command, ping 192.168.0.58, the destination The problem is you forgot to configure the BT network adaptor. After you install MiniBluelet PAN or Bluesoleil, a BT network adaptor will be found in Device Manager dialog. You should configure the BT network adaptor manually.
	I have disabled BT network adaptor and enabled my former network card, but my network doesn't work properly. Or I have disabled my former network and enabled BT network adaptor, but I cannot make connection to a P If the former case occurs, please disable your former network card, and then enable it again. In the same way, if BT network adaptor does not work well, please disable it, and then enable it again.

下载文件